Alright, so I'm finally almost finished with my wolf partial (after getting sidetracked for way too long), but I've run into some trouble with the tail...
I decided to make the tail with a hollow 1/2 in. foam shell for a core, which seemed to work great except that it's rather flat. I made the shell with two identical pieces of foam wrapping toward each other to glue edge-to-edge, but the tension doesn't seem to be enough to make it keep a round shape. So now I'm not quite sure what to do. I thought about using wire, but I'd rather keep it foam to keep it all soft. Any ideas?
Image may be NSFW.
Clik here to view.
From the side.
Image may be NSFW.
Clik here to view.
And from the top. Notice it looks a bit flat. It's a little hard to see in the picture, but look especially at the tip on the right side.
Any help would be greatly appreciated!
I decided to make the tail with a hollow 1/2 in. foam shell for a core, which seemed to work great except that it's rather flat. I made the shell with two identical pieces of foam wrapping toward each other to glue edge-to-edge, but the tension doesn't seem to be enough to make it keep a round shape. So now I'm not quite sure what to do. I thought about using wire, but I'd rather keep it foam to keep it all soft. Any ideas?
Image may be NSFW.
Clik here to view.

From the side.
Image may be NSFW.
Clik here to view.

And from the top. Notice it looks a bit flat. It's a little hard to see in the picture, but look especially at the tip on the right side.
Any help would be greatly appreciated!