Hey there!
So I had this problem once before but I wasn't too sure on the cause last time so it was a little hard to pinpoint exactly what I needed to fix the situation.
This time I'm pretty sure I found the root of the problem so I am trying again for advice!
I am once again trying to fit a body to a DTD, but it seems like because the DTD was made with the arms down instead of held out to the side that I am now getting a strange fit where there isn't a lot of range of motion in the arms.
Last time I had this issue I added some gussets to the armpit areas and that seemed to help; but now that I know the exact problem I'm wondering if there are any other solutions out there that people have found.
If not then I will attempt the gussets again.
Thanks!
So I had this problem once before but I wasn't too sure on the cause last time so it was a little hard to pinpoint exactly what I needed to fix the situation.
This time I'm pretty sure I found the root of the problem so I am trying again for advice!
I am once again trying to fit a body to a DTD, but it seems like because the DTD was made with the arms down instead of held out to the side that I am now getting a strange fit where there isn't a lot of range of motion in the arms.
Last time I had this issue I added some gussets to the armpit areas and that seemed to help; but now that I know the exact problem I'm wondering if there are any other solutions out there that people have found.
If not then I will attempt the gussets again.
Thanks!