Smiley husky redline?

I'm working on a smiley/derpy husky suit at the moment, and would appreciate any advice or redlines!



This head is actually built off of a 3D printed base (specifically this one here) that was way too small for the commissioner, so I had to pull all the pieces apart and expand them carefully. Due to that, the lower jaw is going to be permanently slightly open while on the commissioner, which works perfectly for the derpy expression he wanted. One of the ears is also going to be a bit floppy, which is why it's been chopped off :P

I've also had to pad it out a ton to try and lessen the blocky shapes of the base itself, and dremel out larger eye-holes for a toonier look. The printed "face" is stuck to a baseball-cap like thing so it's not as claustrophobic as a balaclava.

If anyone thinks anything should be adjusted, please let me know! This is the first base of this type I've worked with, and the first time I've had to foam anything this extensively. The only thing I can maybe think of doing is taking the upper edge of the smile and bringing it down towards the muzzle some.